Joined
·
7 Posts
Hi all. We had a smart meter installed a few days ago and since then our Syncev charger isn't working properly.
First we noticed that the consumer unit had tripped (after the electrician had left - house electrics were fine)
Resetting the fuse got the charger showing its LED lights as normal
Woke up the next day with it flashing saying there was a fault. Tried a soft reboot and hard reboot. Unit didn't come back around
Later on, it seems to have come back to life
Try a charge an immediately get a error from the car
Try a hard reset for several minutes, turn back on and nothing... About an hour later its back to life. Try another charge and all working fine!!!... For 5 mins then it gets a fault again and charging ceases.
Here are some photos of the meter etc, any ideas?
![Fixture Electricity Electrical wiring Cable Gas]()
![Rectangle Material property Gas Brick Brickwork]()
First we noticed that the consumer unit had tripped (after the electrician had left - house electrics were fine)
Resetting the fuse got the charger showing its LED lights as normal
Woke up the next day with it flashing saying there was a fault. Tried a soft reboot and hard reboot. Unit didn't come back around
Later on, it seems to have come back to life
Try a charge an immediately get a error from the car
Try a hard reset for several minutes, turn back on and nothing... About an hour later its back to life. Try another charge and all working fine!!!... For 5 mins then it gets a fault again and charging ceases.
Here are some photos of the meter etc, any ideas?
