Speak EV - Electric Car Forums banner
1 - 3 of 3 Posts

·
Registered
2018 Leaf 40kwh Tekna
Joined
·
190 Posts
I hardwired my dashcam into the heater fan fuse. I think another option for a switched fuse would probably be heated seats or wipers. The wires then run under door seals and roof lining.

Plenty of videos on youtube to help I found.

Cheers
 

·
Registered
2018 Leaf 40kwh Tekna
Joined
·
190 Posts
No worries, I could upload a picture of my set up if thatd be helpful?

Jonno
 

·
Registered
2018 Leaf 40kwh Tekna
Joined
·
190 Posts
Vehicle Automotive lighting Hood Motor vehicle Automotive tire
Automotive tire Motor vehicle Rim Material property Electrical wiring
Electronic engineering Gas Technology Electronic component Electronic device
Wheel Automotive tire Hood Automotive lighting Tire


So mine is plugged into the fuse for blower motor 1. You might need to get some micro fuses as the adapter on mine used different sized fuses to Nissan. Be sure its the right rating. The second photo shows the the earth for the adapter. The cable fits nicely behind the door rubber and tucks in along the headlining. Obviously this is only a forward facing camera and you're fitting a rear facing camera also but I assume once you've sorted cable routing the wiring in should be the same.

Hope this is helpful?

Jonno
 

Attachments

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top