Speak EV - Electric Car Forums banner
1 - 1 of 1 Posts

· Registered
1,299 Posts
Discussion Starter · #1 ·
Hi all

Just had our consumer unit replaced yesterday. The set up before was a pod point 7kW charger, going to a mini consumer unit with a C40 breaker in it. That went back to the consumer unit (6mm cable) with a B40 MCB in the non RCD side of the consumer unit.

We have now had an all RCBO Hager board fitted. The C40 mini consumer unit is the same, but now it goes back to a B32 RCBO rather than the B40 MCB. Does that sound right or should it be a B40 RCBO?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.